att.measurement

att.measurement stellt Attribute zur Beschreibung einer normalisierten oder regularisierten Messung bereit.
Modul tei — The TEI Infrastructure
Mitglieder measure measureGrp unit
Attribute
unit⚓︎ (Einheit) gibt die verwendeten Einheiten an, in der Regel das jeweilige Standardsymbol der gewünschten Messeinheiten.
Zustand Optional
Datentyp teidata.enumerated
Empfohlene Werte sind:
m
(Meter) SI-Basiseinheit der Länge
kg
(Kilogramm) SI-Basiseinheit der Masse
s
(Sekunde) SI-Basiseinheit der Zeit
Hz
(Hertz) SI-Einheit der Frequenz
Pa
(Pascal) SI-Basiseinheit des Drucks
Ω
(Ohm) SI-Einheit des Widerstands
L
(Liter) 1 dm³
t
(Tonne) 10³ kg
ha
(Hektar) 1 hm²
Å
(Angström) 10⁻¹⁰ m
mL
(Milliliter)
cm
(Zentimeter)
dB
(Dezibel) siehe Anmerkungen unten
kbit
(Kilobit) 10³ oder 1000 Bits
Kibit
(Kibibit) 2¹⁰ oder 1024 Bits
kB
(Kilobyte) 10³ oder 1000 Bytes
KiB
(Kibibyte) 2¹⁰ oder 1024 Bytes
MB
(Megabyte) 10⁶ oder 1 000 000 Bytes
MiB
(Mebibyte) 2²⁰ oder 1 048 576 Bytes
unitRef⚓︎ points to a unique identifier stored in the xml:id of a unitDef element that defines a unit of measure.
Zustand Optional
Datentyp teidata.pointer
quantity⚓︎ (quantity) specifies the number of the specified units that comprise the measurement
Zustand Optional
Datentyp teidata.numeric
commodity⚓︎ (commodity) indicates the substance that is being measured
Zustand Optional
Datentyp 1–∞ Vorkommen von teidata.word durch Leerzeichen getrennt